Cengiz wrote: Mon May 06, 2024 5:49 am Hello mrtools, unfortunately I could not test because I got this message.

Looking at the message you changed the name, try downloading it again and leave the name the same.

mrtools wrote: Mon May 06, 2024 5:57 am Looking at the message you changed the name, try downloading it again and leave the name the same.

It's working now.
Thank you very much.

First of all, I would like to wish all the fathers here a happy Father's Day.
Found this indicator here in forum and wanted to ask if one of the programmers can add MTF and ON/OFF switch.
Many thanks in advance.

Add mtf plz

Intrest 1 wrote: Mon Jun 24, 2024 2:29 am Add mtf plz

I uptade code and added mtf...

Thank you.

Can I ask you to make an random walk index delta indicator that displays the degree of divergence of index lines approximately like in the picture?

I depicted how, on the downward movement after the histogram indicator's signal, the delta will change color depending on the convergence and divergence of the lines.

• If during the downward movement the distance between the lines increases, then the color is histogram red
• If the distance between the lines decreases, then the color is histogram is green

mrtools wrote: Sat Jan 19, 2019 6:10 am

Hello mrtools.

MTF mode is not working properly.
I downloaded all the historical data.
But the values ​​I am seeing are way off the price.

Could you check please?

An example is shown below.
Setting 15 minute indicator on M5 chart

t2g wrote: Thu Jun 27, 2024 5:13 pm Hello mrtools.

MTF mode is not working properly.
I downloaded all the historical data.
But the values ​​I am seeing are way off the price.

Could you check please?

An example is shown below.
Setting 15 minute indicator on M5 chart

Hello,

Yep, you're right not sure how to fix it, am looking into it.

Hello,

it is possible check this indicator? MTF work only for higher time frame (if i have open H1, MTF show only H1, H4, D1...) I want to show lower timeframe for example H1 chart and indicator show M30.

Thanks

Dear mladen & mrtools,

Can the below indicators have the custom TF option (for analyzing renko/range/seconds charts)

[also, can they be made to give signals only on bar close/confirmed bar (instead of recalculating the current/open bar)


Thanking you in anticipation for your great contributions & efforts


Best Regards,
SS