Is the usage of the following "FNC_DB2" parameter correct?dacanba wrote: Sun Jan 07, 2024 12:25 pm Hello Funchi
I have been testing several indicators, alone and combined, and I have found that when there is more than one indicator the system takes all that are used for input as output and does not consider the established criteria as output. For example, if I use ema, macd and rsi as inputs and only ema and macd as output, the test considers the three inputs to output, when there should only be two.
As a result of the same thing, I imagine, sometimes analyzing a pair gives me one result and then it can give me a totally different one.
Greetings and thanks
Signal Match ratio for Entry (%GE)
Signal Match ratio for Exit (%LT)
Signal Match ratio for Exit (%GE)
If the Signal Match ratio for Exit (%GE) is non-zero, the Signal Match ratio for Exit (%LT) is invalid.
If the Signal Match ratio for Exit (%GE) is zero, the Signal Match ratio for Exit (%LT) is valid.
Also,
Entry/Exit is not ordered on a new bar.
Orders are placed at fixed time.
The signal update timing is determined by the parameters "Sending interval minutes" and "Judge Delayed seconds" for each indicator.
It does not wait for a new candlestick to appear.
(We are considering system response to this issue so that signals are updated after waiting for a new candlestick.)
Or,
I may not be understanding what you mean in your post.
I am easier to understand when I have the actual setup and its results.
Or,
If I know what I want to do, I can set up the template.