thomdel wrote: Thu Nov 07, 2019 10:56 pm


Rijay Sir,

I tried today in Live markets on different time frame charts.
example : 1 hour Jurik filter for EA on 15 min / 30 min Chart.
Arrows come and disappear. Also Arrows Appear on Past Bars after a certain movement.

Parameters I am following from your rijay jma tpl.
Also tried different settings and parameters too but This Issue Persists.

Please Advise...if I am doing something wrong.


Thanks & Regards.

mrtools wrote: Fri Nov 08, 2019 1:55 am

You can add or remove the levels you need on the first line here Levels = "0.382;0.618;1";

Cazz223 wrote: Fri Nov 08, 2019 3:10 am Re: "Code Numbers" relative to "Prices"

Dear MrTools
I wonder for those indis without the list of Prices to select from (but to fill in a number/digit), can I assume that the Prices are as follows?
(Some indis can go as far as up to "5")

0 = Close
1 = Open
2 = High
3 = Low
4 = Median
5 = Typical
6 = Weighted
7 = Average (high+low+open+close)/4
8 = Average median body (open+close)l2
9 = Trend biased price
10 = Trend biased (extreme) price
11 = Heiken ashi close
12 = Heiken ashi open
13 = Heiken ashi high
14 = Heiken ashi low
15 = Heiken ashi median
16 = Heiken ashi typical
17 = Heiken ashi weighted
18 = Heiken ashi average
19 = Heiken ashi median body
20 = Heiken ashi trend biased price
21 = Heiken ashi trend biased (volume) price
22 = Heiken ashi (better formula) close
23 = Heiken ashi (better formula) open
24 = Heiken ashi (better formula) high
25 = Heiken ashi (bener formula) low
26 = Heiken ashi (better formula) median
27 = Heiken ashi (better formula) typical
28 = Heiken ashi (better formula) weighted
29 = Heiken ashi (better formula) average
30 = Heiken ashi (better formula) median body
31 = Heiken ashi (better formula) trend biased price
32 = Heiken ashi better formula trend biased (extreme)

Deez wrote: Thu Nov 07, 2019 11:34 pm

Haven't seen the indicator but if filter is set to 1hr tf and the indicator is on a 15/30min chart then the arrows will recalculate(not repaint) until that 1hr bar is complete. That could be the issue..please check.

mrtools wrote: Fri Nov 08, 2019 2:15 am

That is normal behavior when using the arrows in mtf mode, it's not really a valid signal until the 15 or 30 minute bar is complete within the hourly chart.

dansmol wrote: Fri Nov 08, 2019 10:14 am Gentlemen,
This is an help request for all the contributors of this site.
In the old time of TSD-forex I found an indicator( I don't remember who made it , maybe mrtools or mladen or xard )
which plot a vertical line ,moving with every new candle .
I don't even remember the name of the indicator.
maybe somebody can help me to find it .
Thank you very much for your time
ALL THE BEST
Dan

mrtools wrote: Fri Nov 08, 2019 2:09 am

The arrows shouldn't repaint except when used in mtf, but noticed the jurik function wasn't called correctly, should be better in this version.

thomdel wrote: Fri Nov 08, 2019 4:25 pm


Respected Sir,
Thanks for this version.
Thanks for your support, generosity, efforts & shares.

Please clear this doubt.

There has been a upload previously by you for showing Timeframe Text : Jurik filter (text) ( timeframe text & colouring for bars added by you )
Is this version : Jurik filter (text) proper ? i.e jurik function called correctly ?

There is another version on this forum very much earlier : Jurik filter (mtf + alerts + fl's) ( does not have time frame text, colouring for bars - has floatings )
Is this version : Jurik filter (mtf + alerts + fl's) proper ? i.e jurik function called correctly ?


Thanks & Regards.