I think RSIOMA is slow.funchi wrote: Thu May 29, 2025 11:06 am Sorry.
Some indicators are very slow and cannot be dashboarded.
I do not know the cause.
I will create it again after my knowledge of MT5 improves.
Hi Funchi !funchi wrote: Thu May 29, 2025 5:11 pm This tool does not require the use of THE ALKEMIX SATURN template.
The following files are now supported for use if they are loaded.
Incidentally, the value of the UniqueID parameter of each Oracle indicator must be set to the UniqueID of this tool.
(The same value as in the template has already been set initially)
Alkemix Structure
Alkemix Trend
Alkemix Oracle
Alkemix Oracle 2nd (V2 is MTF)
.funchi wrote:
Sorry.
Some indicators are very slow and cannot be dashboarded.
I do not know the cause.
I will create it again after my knowledge of MT5 improves.
The current state of the signals is not EA-able.DmitrySCLP wrote: Thu May 29, 2025 9:55 pm Hi Funchi !
Thanks for the great work !
Is EA for mt5 planned for these signals?
For example, setting the decision bar to 4 will result in a delayed decision.asgariHoo wrote: Fri May 30, 2025 5:27 am HI mr Funchi.
If i want use FNC-2ndDot_v2 in parameter 250 50. How to stay signal buy or sell until semafor 750, and the signal does not show as flat? The signal shows flat and resets after reaching semafor 250
Any suggestions?
.
Every indicator that signals recently does not work properly.FiveS wrote: Thu May 29, 2025 5:09 pm I think RSIOMA is slow.
"RI 2 11:31:35.295 XU RSIOMA_HISTO with USI (GBPJPY+,M5) indicator is too slow, 2391 ms. rewrite the indicator, please"
How about the other three indicator signals? gann, dz adx and jurik volty. Can they signals be dashboarded?
What are the glitches in the PR indicator signals?rsistoch wrote: Thu May 29, 2025 9:47 am I did a quick check and I can see that the FNC kingfisher gives the correct signal but the PR is not correct. If I set the bar to check to 0 in the FNC PR, I will not get any signal, all flat, setting it to 1 will get some wrong signals.
During the process of using the PR, I also encountered it appearing and disappearing a few times.
If possible, please see my question about the FNC TDI.
post1295566380.html#p1295566380
よろしくお願いいたします!!!
rsistoch wrote: Thu May 29, 2025 11:20 am I expect to receive an UP signal when RPL above TSL and MBL, even when TSL below MBL, the signal is still UP.
I just find it gives wrong signal.
