Dear MrTools,
First of all, thank you very much for the excellent indicators and tools you have shared with the community over the years and fulfilling my previous requests.
If time permits, I would be very grateful if you could consider enhancing any one of the existing Fractal Channel indicators that you have already coded and shared.
Specifically, I was wondering if it would be possible to modify any Fractal Channel indicator to draw filled Fractal Boxes, using straight vertical boundaries instead of the current slanting or sloping vertical lines.
I have come across a few Fractal Channel indicators on the forum, and it would be wonderful if this filled box feature could be added to any one of them.
post1295476180.html#p1295476180
post1295482056.html#p1295482056
post1295475357.html#p1295475357, (This one plots a filled version but need box like straight vertical lines)
The idea is for the indicator to visually resemble Fractal Boxes, where each box is formed using the previous two confirmed fractals (as shown in the attached screenshot). Since fractals repaint and are only confirmed after the close of the second bar, it would be very helpful to have an option that:
I have attached the screen shot as picture explains better than words and might be I am unable to explain my point clearly.
Uses the confirmed fractal status only after the second bar closes for adjusting the high /low of the fileld fractal box
Until confirmation, the filled area extends based on the previous confirmed fractal high and low
Once a new fractal is confirmed, the filled box automatically adjusts to reflect the newly confirmed .
Option for Look Back period/ bars to plot the filled area.
I fully understand your time constraints and will be extremely thankful if this enhancement is possible at your convenience.
Thank you once again for your continued support and valuable contributions to the community.