The initial parameter value is the content of the request.iardavan wrote: Fri May 23, 2025 11:50 pm Everything seems fine. In the 750/50/10 mode, the signal is received, but in the 250/50/10 mode, fewer conditions occur for the signal to be triggered.
Now, I want to see what numbers I should set if I want to take entry points based on the picture. I'm testing it and will share the results here by next week.
Options like this example, regardless of having anchored VWAP, should be as follows:
250/10/10/10 and on the Semafor10 display, the fourth E or Entry, or other modes.
Another request, if possible:
Could it have a section like in the FNC_2ndDot_v2 version called "Signal Middle Name" for explanations, so we know what this column refers to?
Thanks for the time you put in, dear Funchi.
I hope I’ve conveyed my point clearly.
put some example via picture...
Zero From parameter is not checked.
From-To of 0-1 is not checked; 0-1 is the same as 0-0.
If the opposite Semafor is displayed, the signal cannot continue.
If you have a good idea, please let me know. There is no solution so far.
For example, if the opposite Semafor is displayed, the previous signal will continue to be displayed until the status of the next signal is determined. etc.
