funchi wrote: Fri May 23, 2025 8:48 am It should be displayed but it is not?
If this is the case, please tell us.

If the timing is missed, the signal will not be displayed.

The small dot ‘Count From’ and ‘Count To’ parameters are currently set to 2-2.
Wait for the small dot to appear twice.

If set to 1-2
The signal is displayed whether the small dot is displayed once or twice.
If set to 0, the check is skipped.

Everything seems fine. In the 750/50/10 mode, the signal is received, but in the 250/50/10 mode, fewer conditions occur for the signal to be triggered.

Now, I want to see what numbers I should set if I want to take entry points based on the picture. I'm testing it and will share the results here by next week.

Options like this example, regardless of having anchored VWAP, should be as follows:

250/10/10/10 and on the Semafor10 display, the fourth E or Entry, or other modes.

Another request, if possible:

Could it have a section like in the FNC_2ndDot_v2 version called "Signal Middle Name" for explanations, so we know what this column refers to?

Thanks for the time you put in, dear Funchi.

I hope I’ve conveyed my point clearly.

put some example via picture...