I am trying to add signals from higher timeframes to the chart but the arrows on all timeframes point in the same direction. I don't know much about writing code, but I guess even worse I can't figure out how to use the written interface :/1337br wrote: Tue Jan 14, 2025 12:18 pm Strategy 2, how to use it for smaller time frames (m1, m5, m15)
1) Gann Made Easy buy signal, then go up 1 or 2 time frames and check if the smart level trader is showing buy signals (to confirm the Gann signal)
Smart Level Trader buy signals = uptrend, buy, reversal (continuation)
The summary of the attached example shows that the Gann signal was made on M1, after going up to M5 it was confirmed with buy signals (2x) + reversal signal (attached photos)
*The summary is that the confirmation of the smart level trader needs to be 1 or two time frames above the Gann signal, always following if it is a buy = Gann signal + buy, uptrend, reversal (on larger time frames)
If it is a sell = Gann signal + downtrend, sell, reversal (on larger time frames)
Preferably two signals together
buy+buy or buy+reversal or uptrend+buy (strong confirmation of buying on the higher time frames of the gann signal)
if it is a confirmation of selling sell+sell or sell+reversal or downtrend+sell (strong confirmation of selling on the higher time frames of the gann signal)
*in the second example with photos the gann signal appears in m5
after rising to m15 to seek confirmation there was buy+buy
after rising to m30 there is also confirmation of uptrend (so it was confirmed that the m5 signal is good because m15 and m30 have purchase confirmations)
Which numbers should I enter in the signal column number?
