TradeXtra wrote: Fri Jun 23, 2023 9:38 am Funchi here's a the template I created for X-Gen.
Please check it.
Hope I did it right?

3xXXuma is the same as the direction of entry,
MA and TDI regardless,
If the ORDER turns the other way, it's an EXIT.

In other words,
If the order goes in the opposite direction, it is an exit.


In this case, the settings are as shown in the image below.


There are two main ways to set up an exit.

1. the match ratio is smaller than the set value.
"Signal Match ratio for Exit (%LT)".
For example,
There is no superiority or inferiority of singles,
If more than 1 out of 4 conditions are mismatched, the value is set to 100.
If two or more of the four conditions disagree, set the value to 75.

2. the match ratio is greater than the set value.
"Signal Match ratio for Exit (%GE)".
For example,
If both the A and B signals are opposite, set the value to 100.
If either the A or B signal is opposite, set the value to 50.


In this case, if only the ORDER signal turns the opposite direction,
Set "Signal Match ratio for Exit (%GE)" to 100.


Also,
I think it's probably OK, but (sorry, I'm uncertain)
I set this up conventionally.

Enter in the direction of signal 1.
The "same", "different", or "opposite" setting is based on Signal 1.
Therefore, Signal 1 is a more suitable signal for MA than for ORDER.


The rollover time is long.
During rollover, it is equivalent to unconnected.
It does nothing.

There is a schedule function.
It is better to use this one.
"FNC_dashboard_scheduler".

The others are good.