Making changes on the Exit

The exit indicator simply appears AFTER the appearance of ANY of the semaphore values. Buy exit will be above the fast MA and short exit the semaphore will be below the fast MA. After Semaphores are infamous for the repaints - take this into consideration when using the Exit indicator BUT insofar as entry is concerned I doubt it repaints within the allowed range 0f 16 candles AFTER a MA crossover.


Hi all.
Just thinking about the Exit indicator, if you change the semaphore values to ALL THE SAME VALUES THEN ONLY THAT PARTICUALR SEMAPHORE EXIT WILL BE DISPLAYED.
What I mean is that usually the first value, for example 9, will reflect a minor pull back/ retrace whereas value 88 reflects a change of direction. Value 36 is basically the second dot so that looks good to use for an exit. Thus, MAKE ALL THE SEMAPHORE VALUES 36 IN THE INPUT SECTION and see how that shows on your charts together with the standard system Semaphores also showing. You will see it ignoring the first and last semaphore.

You know what just try any of the 3 values and decide?

I am also thinking of enhancing the exit to a situation to only show when it is either a close of a bullish/bearish candle. Just need to think it through and code. Will let you all know once done.

Finally MAKE SURE YOU ALSO PLACE THE 3-level-zz-semafor LD indicator into your Indicators folders. These will not work without that AND you need not do anything here with it input values.

Regards